The topic content brings theoretical contents that will be important to perform and understand the experiments, and explains the process plant and system.

It´s interesting that you have a look at it before start working. You may study it before working on the experiments, or consult it as you need.

When you access the first experiment you will verify that you must perform it in 4 steps:

Step 1: Assembly

Step 2: Wiring

Step 3: Setup

Step 4: Measurements

At this step you will assemble the pieces that you need at the rack and at the table following the instructions in the assembly section.

It´s important that you place every module in the position specified in the content.

When you have finished the assembly, press the CHECK ASSEMBLY button.

The Smartsim helps you all the way along the experiments. So if you make any mistake it´s going to report it to you when you presss the CHECK button.

At the wiring step you will connect the sensors and actuators to the modules as specified in each experiment.

In the setup step, you should make sure that everything is setup as specified. In this case the setup is related to the position of some keys.

After verifying the setup you must perform the measurements following the procedure step-by-step.

You must fill the measurement´s table with your results and press "delivery" to validate your experiment.